Well I started with a some pixels on a screen as I designed what I thought would be two warring factions in my new rules that I am in the process of writing. Actually to be honest I wanted two forces to use in my own games, so I set about designing the two lots of ships. I next printed out all [Read more...]
I have had a busy week getting everything ready for the first print of the new game. I managed to get it all printed, stuck onto thin card, cut out, put into card sleeves, and even laminated a few pieces this evening. The process has taken a while—getting the designs just right to match the [Read more...]
I have been busy working on The Last Drifters Salute 51 game board and vehicles over the last week and a bit, I have managed to get a lot more done then in the previous week which is good, but I still have a long way to go. So here is what I have done so far… The XPS foam has been stuck down [Read more...]
I spend a little while today painting up the 3D printed scenery I printed out a few days ago, this post is just a quick run though of what I did to get them up to table top ready. First off I stuck the prints to some 1.5mm plasticard cut to give bases for the scenery, I then added some small [Read more...]
Well illness has taken me away from hobby stuff for a while now ( no posts on here for a couple of weeks!! ) but as I have started to get better, I have managed to get in a few hours at my PC over the last couple of days. And I decided to design some 3D sci-fi scenery to use with my new rules [Read more...]