3D 6mm scenery finished

I spend a little while today painting up the 3D printed scenery I printed out a few days ago, this post is just a quick run though of what I did to get them up to table top ready. First off I stuck the prints to some 1.5mm plasticard cut to give bases for the scenery, I then added some small [Read more...]

New 3D Sci-Fi Scenery

Well illness has taken me away from hobby stuff for a while now ( no posts on here for a couple of weeks!! ) but as I have started to get better, I have managed to get in a few hours at my PC over the last couple of days. And I decided to design some 3D sci-fi scenery to use with my new rules [Read more...]